The primary things the do-it-yourselfer realizes when learning building a drywall ceiling is that no man is an island – unless he uses rented equipment! Since the panels are big, bulky, and awkward, hanging drywall with a ceiling entails one or the other: the aid of another person or renting a drywall jack from the local home improvement center. The cable mechanism on drywall jacks just isn’t tough to operate, and jacks do a great job of holding the drywall inside a secure, flat position helping you to quicker attach it on the ceiling.
Tools & Materials
How to construct a Ceiling Drywall Installation includes understanding what all tools and material you’ll need. In addition to either another person to help you or perhaps a drywall jack, you’ll also require a hammer, a drill with a screwdriver bit, and nails or screws for drywall. You’ll also, of course, should measure your ceiling (twice!) and buying enough drywall, including a little extra in case there is mistakes, to do the job.
Mark Joists First
Get the boards – usually 2x4s or 2x6s – that work as ceiling joists by tapping along the wall studs with a hammer and following up the wall on the ceiling. As part of finding out how to make a drywall ceiling, mark where these boards can be found with a pencil. These are generally what you will be attaching the drywall to and marking them beforehand helps it be much easier to locate them than searching for them as you are nailing or screwing on the drywall. After this you should measure the place that the permanent fixture continues on the drywall and cut out a dent to accommodate that part of the ceiling.
The hard Part
Now’s the part to learn building a drywall ceiling where you’ll need each other (who hopefully has lots of stamina as well as strength!) to support the drywall up to the ceiling as well as to place the drywall panel on the jack. Position the end from the sheet of drywall – having its finished side facing down – in the center from the ceiling board (joist) to which you are going to nail it. Nail across the not in the panel in regards to a half an inch from your edges to prevent the drywall from splitting or cracking. The individual that is holding the panel are now able to move or, should you be by using a jack, it is possible to move against each other of how.
Help it become Pretty
Countersink nails or screws at six- or seven-inch intervals all along the length of the joist to which the drywall may be attached. Countersinking enables you to conceal the heads from the nails/screws with compound so that if you paint, the heads will not be whatsoever visible. Although not really a part of focusing on how to construct a drywall ceiling, finding out how to conceal ugly nail or screw heads serves its own purpose for overall general carpentry knowledge.
To get more information about Ceiling Drywall Installation view our new web portal: this site